ProCurve 420 Manual do Utilizador descarregar pdf (Página 10)

Software Management

Note

Downloading new software does not change the current access point configuration. The access point

configuration is contained in a separate file that can also be transferred, for example, for archive

purposes or to be used in another access point of the same model. HP recommends that you save a

copy of the configuration file before updating your access point software. See “Transferring Config-

uration Files” in the HP ProCurve Wireless Access Point 420 Management and Configuration Guide

for information on saving the access point’s configuration file.

To Update the Access Point to v2.1.x Software From v2.0.x Software:

1. Download the temporary software file, hp420-tempimg2.bin.

2. After a successful download, the prompt “Do you want to use NEW CONFIG SETTINGS? <y/n> [n]:”

appears. Type “n” to retain the current access point configuration. (Typing “y” restores factory

default settings and reboots the access point.)

3. Reboot the access point.

HP420#copy tftp file

1. Application image

2. Config file

3. Boot block image

Select the type of download<1,2,3>: [1]:1

TFTP Source file name:hp420-tempimg2.bin

TFTP Server IP:192.168.1.10

Removing old runtime! Please wait a few minutes!

Creating file! Please wait a few minutes!

Firmware version of system is v2.0.38.0B037 and Updating Run-Time code

v02.00.40 NOW!

Updating Boot Line in NVRAM, please wait!

Warning! Updating firmware may cause configuration settings to be

incompatible.

(Suggestion:Using new default configuration settings lets system be more

efficient,but system will lose current settings.)

Do you want to use NEW CONFIG SETTINGS? <y/n> [n]:n

HP420#

HP420#reset board

Reboot system now? <y/n>: y

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 36 37

Sem comentários

ProCurve 420 Manual do Utilizador Página 10