ProCurve 2510G Series Informações Técnicas descarregar pdf (Página 189)

10-13

Port Status and Basic Configuration

Viewing Port Status and Configuring Port Parameters

If you want more information on this subject please refer to the IEEE 802.3ab

Standard Reference.

For more information on MDI-X, refer to the appendix titled “Switch Ports and

Network Cables” in the Installation and Getting Started Guide for your

switch.

Manual Auto-MDIX Override

If you require control over the MDI/MDI-X feature you can set the switch to

either of two non-default modes:

■ Manual MDI

■ Manual MDI-X

Table 10-2 shows the cabling requirements for the MDI/MDI-X settings.

Table 10-2. Cable Types for Auto and Manual MDI/MDI-X Settings

The Auto-MDIX features apply only to copper port switches using twisted-pair

copper Ethernet cables.

MDI/MDI-X Device Type

Setting PC or Other MDI Device Type Switch, Hub, or Other MDI-X Device

Manual MDI Crossover Cable Straight-Through Cable

Manual MDI-X Straight-Through Cable Crossover Cable

Auto-MDI-X

(The Default)

Either Crossover or Straight-Through Cable

Syntax: interface < port-list > mdix-mode < automdix | mdi | mdix >

automdix is the automatic, default setting. This configures the

port for automatic detection of the cable (either straight-through

or crossover).

mdi is the manual mode setting that configures the port for

connecting to either a PC or other MDI device with a crossover

cable, or to a switch, hub, or other MDI-X device with a straight-

through cable.

mdix is the manual mode setting that configures the port for

connecting to either a switch, hub, or other MDI-X device with

a crossover cable, or to a PC or other MDI device with a straight-

through cable.

Syntax: show interfaces config

Lists the current per-port Auto/MDI/MDI-X configuration.

1 2 ... 184 185 186 187 188 189 190 191 192 193 194 ... 411 412

Sem comentários

ProCurve 2510G Series Informações Técnicas Página 189