ProCurve 2510G Series Informações Técnicas descarregar pdf (Página 191)

100

101

10-15

Port Status and Basic Configuration

Viewing Port Status and Configuring Port Parameters

Note Port Response to Switch Software Updates

■ Switch software updated from xx.xx.xx or earlier

1. Copper ports in auto-negotiation still default to auto-mdix mode.

2. Copper ports in forced speed/duplex default to mdix mode.

The default is auto-mdix. If the switch is reset to the factory defaults, these

ports are configured as auto-mdix. Use the following CLI command to change

the setting for individual ports:

interface < port-list > mdix-mode < automdix | mdi | mdix >

Web: Viewing Port Status and Configuring Port

Parameters

In the web browser interface:

1. Click on the Configuration tab.

2. Click on Port Configuration.

3. Select the ports you want to modify and click on Modify Selected Ports.

4. After you make the desired changes, click on Apply Settings.

Note that the web browser interface displays an existing port trunk group.

However, to configure a port trunk group, you must use the CLI or the menu

interface. For more on this topic, see Chapter 11, “Port Trunking“.

1 2 ... 186 187 188 189 190 191 192 193 194 195 196 ... 411 412

Comentários a estes Manuais

Sem comentários

ProCurve 2510G Series Informações Técnicas Página 191

Comentários a estes Manuais