ProCurve 2510G Series Informações Técnicas descarregar pdf (Página 338)

100

101

B-26

Monitoring and Analyzing Switch Operation

Port and Static Trunk Monitoring Features

CLI: Configuring Port and Static Trunk Monitoring

Port and Static Trunk Monitoring Commands Used in This Section

You must use the following configuration sequence to configure port and

static trunk monitoring in the CLI:

1. Assign a monitoring (mirror) port.

2. Designate the port(s) and static trunk(s) to monitor.

Monitoring Limitations

The following limitations apply to monitoring and mirroring for the switches

covered in this guide:

■ Normal traffic flow to the mirror port is blocked when mirroring is

enabled.

■ If IGMP snooping is enabled, IGMP packets cannot be mirrored.

■ The mirror port always has traffic tagged if the mirror port is not in the

same VLAN as the monitored port.

Displaying the Monitoring Configuration. This command lists the port

assigned to receive monitored traffic and the ports and/or trunks being

monitored.

Syntax: show monitor

For example, if you assign port A6 as the monitoring port and configure the

switch to monitor ports A1 - A3, show monitor displays the following:

Figure B-21. Example of Monitored Port Listing

show monitor

mirror-port

monitor

below

page B-27

Port receiving monitored traffic.

Monitored Ports

1 2 ... 333 334 335 336 337 338 339 340 341 342 343 ... 411 412

Comentários a estes Manuais

Sem comentários

ProCurve 2510G Series Informações Técnicas Página 338

Comentários a estes Manuais