ProCurve 2610-PWR Informações Técnicas descarregar pdf (Página 113)

100

101

6-19

Switch Memory and Configuration

Using Primary and Secondary Flash Image Options

Table 6-2. Comparing the Boot and Reload Commands

Booting from Primary Flash. This command always boots the switch from

primary flash, and executes the complete set of subsystem self-tests.

Syntax: boot

For example, to boot the switch from primary flash with pending configuration

changes in the running-config file:

Figure 6-13. Example of Boot Command (Default Primary Flash)

In the above example, typing either a y or n at the second prompt initiates the

reboot operation. Also, if there are no pending configuration changes in the

running-config file, then the reboot commences without the pause to display

Boot from primary flash.

Booting from a Specified Flash. This version of the boot command gives

you the option of specifying whether to reboot from primary or secondary

flash, and is the required command for rebooting from secondary flash. This

option also executes the complete set of subsystem self-tests.

Actions Included In

Boot?

Included In Reload Note

Save all

configuration

changes since the

last boot or reload

Optional,

with prompt

Optional with reload

<cr>, when prompt

displays.

Not saved with reload

at/after commands; No

prompt is displayed.

Config changes saved to

the startup-config file if

“y” is selected (reload

command).

Perform all system

self-tests

Yes No

The reload command

provides a faster system

reboot.

Choice of primary or

secondary flash

image

Yes No—Uses the current

flash image.

Perform a scheduled

reboot

No Yes Use the reload command

with after/at parameters

(see page 6-29 for details).

1 2 ... 108 109 110 111 112 113 114 115 116 117 118 ... 468 469

Comentários a estes Manuais

Sem comentários

ProCurve 2610-PWR Informações Técnicas Página 113

Comentários a estes Manuais

Manuais e produtos relacionados com Software ProCurve 2610-PWR