ProCurve 2610-PWR Informações Técnicas descarregar pdf (Página 346)

100

101

A-6

File Transfers

Downloading Switch Software

CLI: TFTP Download from a Server to Primary

or Secondary Flash

This command automatically downloads a switch software image to primary

or secondary flash.

Syntax: copy tftp flash < ip-address > < remote-os-file > [< primary | secondary >]

Note that if you do not specify the flash destination, the Xmodem download

defaults to primary flash.

For example, to download a switch software file named G0502.swi from a

TFTP server with the IP address of 10.28.227.103 to primary flash:

1. Execute copy as shown below:

Figure A-3. Example of the Command to Download Switch Software

2. When the switch finishes downloading the switch software file from the

server, it displays this progress message:

Validating and Writing System Software to FLASH . . .

3. When the switch is ready to activate the downloaded software you will

see this message:

System software written to FLASH.

You will need to reboot to activate.

At this point, use the boot command to reboot the switch and activate the

software you just downloaded:

ProCurve # boot

(For more on these commands, refer to “Rebooting the Switch” on page

6-18.)

4. To confirm that the switch software downloaded correctly, execute show

system and check the Firmware revision line.

If you need information on primary/secondary flash memory and the boot

commands, refer to “Using Primary and Secondary Flash Image Options” on

page 6-13.

Dynamic counter continually displays the

number of bytes transferred.

This message means that the image you

want to upload will replace the image

currently in primary flash.

1 2 ... 341 342 343 344 345 346 347 348 349 350 351 ... 468 469

Comentários a estes Manuais

Sem comentários

ProCurve 2610-PWR Informações Técnicas Página 346

Comentários a estes Manuais

Manuais e produtos relacionados com Software ProCurve 2610-PWR